Load and Stability Optimization Based Carbon Arm with Split Tank on Unmanned Aerial Vehicle for Foliar Fertilizer
Abstract
This research focuses on the load and stability of unmanned aerial vehicles that are as light as possible but with optimal stability functions and increasing the capacity of liquid fertilizer lifted by unmanned aerial vehicles. The increase in lift is related to the payload and stability to be carried by the unmanned aerial vehicle. By optimizing the arm using the arm carbon method, so without reducing the strength and function of the drone, the gross weight of the components becomes much lighter, so that the weight can be focused on increasing the capacity of liquid fertilizer. With the increase in liquid fertilizer capacity, of course, the weight also increases, this raises a new problem, which is to make the balance value when the drone take-off has a large magnitude, thus affecting stability which causes the potential to fail to fly, therefore this research was carried out so that the drone has stability. maximum and can minimize the effects of shocks from increasing capacity after using arm-carbon. The measurements taken were the success rate of the system in flying over agricultural land, power testing and current measurements. After testing, it was found that by using a split tank and carbon arm system, current and power tend to be more stable, so that battery life is longer, liquid fertilizer capacity can be increased and the potential for flight failure can be minimized with a split tank system with 90% accuracy, carried out optimizing weight with carbon arms and increasing the capacity of liquid fertilizer by 30%, using a split tank system increases the stability of the drone at take-off by up to 80%.
Downloads
References
F. E. Purnomo and F. L. Afriansyah, “Liquid Load Optimization of Unmanned Aerial Vehicle For Foliar Fertilizer,” Prociding ICOFA 2021, vol. 5, pp. 5–9, 2021.
I. Widiastuti, N. Muna, F. L. Afriansyah, and F. E. Purnomo, “Automatic Image Stitching of Agriculture Areas based on Unmanned Aerial Vehicle using SURF,” Prociding ICOFA 2019 , pp. 388–393, 2019.
F. L. Afriansyah, N. Muna, I. Widiastuti, N. Z. Fanani, and F. E. Purnomo, “Image Mapping Detection of Green Areas Using Speed Up Robust Features,” 2019 International Conference on Computer Science, Information Technology, and Electrical Engineering (ICOMITEE), pp. 165–168, 2019.
M. N. Abd. Kharim, A. Wayayok, A. R. M. Shariff, A. Fikri Abdullah, and E. M. Husin, “Droplet deposition density of organic liquid fertilizer at low altitude UAV aerial spraying in rice cultivation,” Computers and Electronics in Argiculture, vol. 167, no. C, 2019.
M. Mozaffari, S. Walid, M. Bennis, and M. Debbah, “Unmanned Aerial Vehicle With Underlaid Device-to-Device Communications: Performance and Tradeoffs,” IEEE Trans Wirel Commun, vol. 6, no. 5, pp. 3949–3963, 2016.
M. Huang, B. Xian, C. Diao, K. Yang, and Y. Feng, “Adaptive tracking control of underactuated quadrotor unmanned aerial vehicles via backstepping,” Proceedings of the 2010 American Control Conference, Baltimore, MD, pp. 2076–2081, 2010.
Z. Song, H. Zhang, F. Liu, S. Chen, and F. Zhang, “Unmanned Aerial Vehicle Coverage Path Planning Algorithm Based on Cellular Automata,” 2018 International Conference on Information Systems and Computer Aided Education (ICISCAE), pp. 371–374, 2018.
F. L. Afriansyah, F. E. Purnomo, N. Z. Fanani, I. Widiastuti, and N. Muna, “Altitude Optimization Using Ultrasonic Sensors Of Unmanned Aerial Vehicle For Foliar Fertilizer,” Prociding ICOFA , pp. 156–160, 2019.
F. Zakharin and S. O. Ponomarenko, “Unmanned aerial vehicle integrated navigation complex with adaptive tuning,” IEEE 4th International Conference Actual Problems of Unmanned Aerial Vehicles Developments (APUAVD), pp. 23–26, 2017.
Q. Xiao et al., “Effect of aviation spray adjuvants on defoliant droplet deposition and cotton defoliation efficacy sprayed by unmanned aerial vehicles,” Journal of Agronomy, pp. 5–12, 2019.
S. Ahmed, B. Qiu, F. Ahmad, C.-W. Kong, and H. Xin, “A State-of-the-Art Analysis of Obstacle Avoidance Methods from the Perspective of an Agricultural Sprayer UAV’s Operation Scenario,” Journal of Agronomy, pp. 2–35, 2021.
V. Khobin and K. Goncharenko, “Perspectives in Applying Variable Structure Systems for Unmanned Aerial Vehicles Landing Control,” 2021 IEEE 6th International Conference on Actual Problems of Unmanned Aerial Vehicles Development (APUAVD), pp. 209–211, 2021.
I. Ostroumov, V. Svirko, and A. Rubtsov, “Unmanned Aerial System Quality Evaluation Based on Ergodesign Analysis,” 2021 IEEE 6th International Conference on Actual Problems of Unmanned Aerial Vehicles Development (APUAVD), pp. 195–199, 2021.
O. Kutsenko, S. Ilnytska, V. M. Kondratyuk, and V. Konin, “Unmanned aerial vehicle position determination in GNSS landing system,” 2017 IEEE 4th International Conference Actual Problems of Unmanned Aerial Vehicles Developments (APUAVD), pp. 79–83, 2017.
V. v. Chikovani, O. Sushchenko, O. v. Petrenko, and S. Yehorov, “Features of Design of Coriolis Vibratory Gyroscopes Assigned for Unmanned Aerial Vehicles,” 2019 IEEE 5th International Conference Actual Problems of Unmanned Aerial Vehicles Developments (APUAVD), pp. 194–198, 2019.
O. Barabash, N. Dakhno, H. Shevchenko, and V. Sobchuk, “Unmanned Aerial Vehicles Flight Trajectory Optimisation on the Basis of Variational Enequality Algorithm and Projection Method,” 2019 IEEE 5th International Conference Actual Problems of Unmanned Aerial Vehicles Developments (APUAVD), pp. 136–139, 2019.
A. Rabello, R. C. Brito, F. Favarim, A. Weitzenfeld, and E. Todt, “Mobile System for Optimized Planning to Drone Flight applied to the Precision Agriculture,” 2020 3rd International Conference on Information and Computer Technologies (ICICT), San Jose, CA, USA, pp. 12–16, 2020.
W. Budiharto, A. Chowanda, A. A. S. Gunawan, E. Irwansyah, and J. S. Suroso, “A Review and Progress of Research on Autonomous Drone in Agriculture, Delivering Items and Geographical Information Systems (GIS),” 2019 2nd World Symposium on Communication Engineering (WSCE), pp. 205–209, 2019.
Copyright (c) 2023 Faisal Lutfi Afriansyah, Fendik Eko Purnomo, Ahmad Rofi'i, Nurul Zainal Fanani
![Creative Commons License](http://i.creativecommons.org/l/by-sa/4.0/88x31.png)
This work is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.